Ethernet Pause; Figure 7 Queue Depth - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

Converged enhanced ethernet
Hide thumbs Also See for Converged Enhanced Ethernet 8000:
Table of Contents

Advertisement

11
Congestion control
consume the full buffer memory. Thresholds can also be used to bound the maximum queueing
delay for each traffic class. Additionally if the sum of the thresholds for a port is set below 100
percent of the buffer memory, then you can also ensure that a single port does not monopolize the
entire shared memory pool.
FIGURE 7
The tail drop algorithm can be extended to support per priority drop thresholds. When the ingress
port CoS queue depth breaches a threshold, then any frame arriving with the associated priority
value will be dropped.
traffic cannot totally consume the full buffer memory. Thresholds can also be used to bound the
maximum queueing delay for each traffic class. Additionally if the sum of the thresholds for a port
is set below 100 percent of the buffer memory then you can also ensure that a single CoS does not
monopolize the entire shared memory pool allocated to the port.
Changing the Tail Drop threshold
To change the Tail Drop threshold, perform the following steps from privileged EXEC mode.
1. Enter global configuration mode.
2. Change the Tail Drop threshold for each multicast traffic class. In this example, 1000pkt is
3. Enter the copy command to save the running-config file to the startup-config file.

Ethernet pause

Ethernet Pause is an IEEE 802.3 standard mechanism for back pressuring a neighboring device.
Pause messages are sent by utilizing the optional MAC control sublayer. A Pause frame contains a
2-byte pause number, which states the length of the pause in units of 512 bit times. When a device
receives a Pause frame, it must stop sending any data on the interface for the specified length of
114
DRAFT: BROCADE CONFIDENTIAL
Queue depth
Figure 7
switch#configure terminal
used.
switch(config)#qos rcv-queue multicast threshold 1000 1000 1000 1000
switch(config)#do copy running-config startup-config
describes how you can utilize this feature to ensure lower priority
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02

Advertisement

Table of Contents
loading

Table of Contents