4
Configuring the FCoE login information
Clearing logins
Perform the following task to clear logins.
Task
Clear the logins that occurred through a front-end
port or from a device specified by the ENode's
VN_port WWN. Syntax is as follows:
•
•
Displaying FCoE configuration-related information
Perform the following tasks to display FCoE-related configuration information.
Task
Display the embedded FCoE port configuration.
Configurations of all the ports are displayed if you
do not specify a specific port.
Display information about devices logged in to a
specific FCoE F_port.
Display FIP configurations.
Configuring the FCoE login information
Another important task in administrating FCoE is configuring the FCoE login information.
Enabling or disabling login configuration management
The fcoelogincfg command allows only configured ENode VN_ports to log in. Use the
fcoelogingroup command to configure allowed ENode VN_ports. The default is disabled.
Disabling the fcoelogincfg command allows unrestricted login on ENode VN_ports.
Perform one of the following tasks to toggle the availability of FCoE login configuration
management.
Task
Enable the FCoE login configuration management
on the switch (this is a switch-based command,
not port-based).
Disable the FCoE login configuration
management on the switch.
26
DRAFT: BROCADE CONFIDENTIAL
-teport slot/port—Specifies the slot or port
number.
-device wwn—Specifies the device WWN.
Command
switch:admin> fcoe --resetlogin -teport slot/port |
-device wwn
Command
switch:admin> fcoe --cfgshow [slot/port]
switch:admin> fcoe --loginshow [slot/port]
switch:admin> fcoe --fipcfgshow
Command
switch:admin> fcoelogincfg --enable
switch:admin> fcoelogincfg --disable
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02