Configuration Management; In This Chapter; Configuration Management Tasks; Cee Configuration Guidelines And Restrictions - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

Configuration management

In this chapter

Configuration management tasks

This chapter describes the typical configuration management tasks you may encounter.
The current configuration on the switch is referred to as the running configuration (running-config).
The running-config file can be written to non-volatile memory to save configuration changes.
Additionally, the running-config file can be saved as the startup configuration (startup-config) file.
When the switch is booted, the system reads the contents of the startup-config file and applies it to
the running-config.
Typical configuration management tasks are as follows:
•
•
•
•
•

CEE configuration guidelines and restrictions

Follow these guidelines and restrictions when performing any CEE configuration management
tasks.
•
•
•
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
•
Configuration management tasks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
•
Flash file management commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
•
Debugging and logging commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23
Saving the startup-config and running-config files to Flash.
Uploading the startup-config and running-config files to a remote location.
Uploading any configuration file saved and stored in Flash to a remote location.
Downloading a configuration file from a remote location to the switch to serve as the
startup-config file or the running-config file.
Downloading a configuration file from a remote location to the switch Flash.
The CEE configuration database is maintained in a file separate from the Fabric OS
configuration database. Note that Fabric OS configuration management remains unchanged.
The CEE configuration is not affected by configUpload and configDownload commands entered
in the Fabric OS shell.
The configuration must be manually saved using the write or copy commands.
Chapter
3
21