Dcbx Interaction With Other Vendor Devices; Lldp Configuration Guidelines And Restrictions; Default Lldp Configuration - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

PFC is defined by a one-byte bitmap. Each bit position stands for a user priority. If a bit is set, the
flow control is enabled in both directions (Rx and Tx).

DCBX interaction with other vendor devices

When the Brocade FCoE hardware interacts with other vendor devices, the other vendor devices
might not have support for the same DCBX version as the Brocade FCoE hardware.
The Brocade FCoE hardware supports two DCBX versions:
•
•
To accommodate the different DCBX versions, the Brocade FCoE hardware provides the following
options.
•
•
•

LLDP configuration guidelines and restrictions

Follow these LLDP configuration guidelines and restrictions when configuring LLDP:
•
•
•
NOTE
DCBX configuration simply involves configuring DCBX-related TLVs to be advertised. Detailed
information is provided in the

Default LLDP configuration

Table 21
TABLE 21
Parameter
LLDP global state
LLDP receive
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
CEE version (1.0.1)—Based on the CEE standard.
Pre-CEE version.
Auto-sense (plug and play)
This is the default. The Brocade FCoE hardware detects the version used by the link neighbor
and automatically switches between the CEE version and the pre-CEE version.
CEE version
Forces the use of the CEE version for the link (auto-sense is off).
Pre-CEE version
Forces the use of the pre-CEE version for the link (auto-sense is off).
Brocade's implementation of LLDP supports Brocade-specific TLV exchange in addition to the
standard LLDP information.
Mandatory TLVs are always advertised.
The exchange of LLDP link-level parameters is transparent to the other Layer 2 protocols. The
LLDP link-level parameters are reported by LLDP to other interested protocols.
lists the default LLDP configuration.

Default LLDP configuration

DCBX interaction with other vendor devices

"LLDP configuration and management" on page 92.
Default setting
Enabled
Enabled
9
91