Applying A Mac Acl To A Cee Interface; Applying A Mac Acl To A Vlan Interface - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

Converged enhanced ethernet
Hide thumbs Also See for Converged Enhanced Ethernet 8000:
Table of Contents

Advertisement

Applying a MAC ACL to a CEE interface

Ensure that the ACL that you want to apply exists and is configured to filter traffic in the manner
that you need for this CEE interface. An ACL does not take effect until it is expressly applied to an
interface using the access-group command. Frames can be filtered as they enter an interface
(ingress direction).
To apply a MAC ACL to a CEE interface, perform the following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to specify the CEE interface type and slot/port number.
3. Enter the switchport command to configure the interface as a Layer 2 switch port.
4. Enter the mac-access-group command to specify the MAC ACL that is to be applied to the Layer

Applying a MAC ACL to a VLAN interface

Ensure that the ACL that you want to apply exists and is configured to filter traffic in the manner
that you need for this VLAN interface. An ACL does not take effect until it is expressly applied to an
interface using the access-group command. Frames can be filtered as they enter an interface
(ingress direction).
To apply a MAC ACL to a VLAN interface, perform the following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter the interface command to apply the VLAN interface to the MAC ACL.
3. Enter the mac-access-group command to specify the MAC ACL that is to be applied to the VLAN
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
switch(config)#interface tengigabitethernet 0/1
2 CEE interface in the ingress direction.
switch(conf-if-te-0/1)#mac access-group test_02 in
switch(config)#interface vlan 50
interface in the ingress direction.
switch(conf-if-vl-82)# mac access-group test_02 in
ACL configuration and management
10
105

Advertisement

Table of Contents
loading

Table of Contents