Configuring Igmp Snooping Querier; Configuring Igmp Snooping Mrouter - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

Converged enhanced ethernet
Hide thumbs Also See for Converged Enhanced Ethernet 8000:
Table of Contents

Advertisement

9. Optional: Activate the IGMP querier functionality with additional features.

Configuring IGMP snooping querier

If your multicast traffic is not routed because Protocol-Independent Multicast (PIM) and IGMP are
not configured, use the IGMP snooping querier in a VLAN.
IGMP snooping querier sends out IGMP queries to trigger IGMP responses from switches that wish
to receive IP multicast traffic. IGMP snooping listens for these responses to map the appropriate
forwarding addresses.
Refer to the CEE Command Reference for complete information about the commands in this
section.
To configure the IGMP snooping querier, use the following procedure from privileged EXEC mode.
1. Enter interface configuration mode.
2. Activate the default IGMP querier functionality for the VLAN.
3. Return to privileged EXEC mode.
4. Set the IGMP querier interval for the VLAN.
5. Set the last member query interval.
6. Set the Max Response Time (MRT).

Configuring IGMP snooping mrouter

To configure IGMP snooping mrouter, perform this task in global configuration mode.
1. Enter interface configuration mode for the VLAN port member.
2. Configure a the port member to be a multicast router interface.
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02
DRAFT: BROCADE CONFIDENTIAL
switch(config)#interface vlan 25
switch(conf-if-vl-25)#ip igmp snooping querier enable
switch(conf-if-vl-25)#exit
The valid range is from 1 through 18000 seconds. The default value is 125 seconds.
switch(config)#ip igmp query-interval 125
The valid range is from 100 through 25500 milliseconds. The default value is 1000
milliseconds.
switch(config)#ip igmp last-member-query-interval 2000
The valid range is from 1 through 25 seconds. The default value is 10 seconds.
switch(config)#ip igmp query-max-response-time 10
switch(config)#interface vlan 10
switch(config-if-vl-10)#ip igmp snooping mrouter interface tengigabitethernet
0/1
Configuring IGMP snooping querier
13
129

Advertisement

Table of Contents
loading

Table of Contents