Lldp Configuration And Management; Enabling Lldp Globally; Disabling And Resetting Lldp Globally; Configuring Lldp Global Command Options - Brocade Communications Systems Converged Enhanced Ethernet 8000 Administrator's Manual

Converged enhanced ethernet
Hide thumbs Also See for Converged Enhanced Ethernet 8000:
Table of Contents

Advertisement

9

LLDP configuration and management

TABLE 21
Parameter
LLDP transmit
Transmission frequency of LLDP updates
Hold time for receiving devices before discarding
DCBX-related TLVs to be advertised

LLDP configuration and management

NOTE
You need to enter either the copy running-config startup-config command or the write memory
command to save your configuration changes to Flash so that they are not lost if there is a system
reload or power outage.

Enabling LLDP globally

The protocol lldp command enables LLDP globally on all interfaces unless it has been specifically
disabled on an interface. LLDP is globally enabled by default.
To enable LLDP globally, perform the following steps from privileged EXEC mode.
1. Enter the configure terminal command to access global configuration mode.
2. Enter LLDP configuration mode.
3. Use the no disable command to enable LLDP.

Disabling and resetting LLDP globally

The protocol lldp command returns all configuration settings made using the protocol lldp
commands to their default settings. LLDP is globally enabled by default.
To disable and reset LLDP globally, perform the following steps from global configuration mode.
1. Enter the protocol lldp command to enter LLDP configuration mode.
2. Disable the LLDP protocol.

Configuring LLDP global command options

After entering the protocol lldp command from global configuration mode, you are in LLDP
configuration mode which is designated with the switch(conf-lldp)# prompt. Using the keywords in
this mode, you can set non-default parameter values that apply globally to all interfaces.
92
DRAFT: BROCADE CONFIDENTIAL
Default LLDP configuration (Continued)
switch(config)#protocol lldp
switch(conf-lldp)#no disable
switch(config)#protocol lldp
switch(conf-lldp)#no protocol lldp
Default setting
Enabled
30 seconds
120 seconds
dcbx-tlv
Converged Enhanced Ethernet Administrator's Guide
53-1002163-02

Advertisement

Table of Contents
loading

Table of Contents