Use Of Internal Hard Disk Drives In The Raid System - NEC EXP339 User Manual

Chapter 2 Preparations
1.7

Use of Internal Hard Disk Drives in the RAID System

This section describes how to use the hard disk drives installed in the HDD cage at the front of the server in
the RAID system.
To build a RAID system, change the jumper switch on motherboard, as shown below.
(a) Using the Software RAID (SW-RAID)
Enable SW RAID by changing jumper setting on motherboard.
Jumper on motherboard (SWRAID)
Change jumper setting to 2-3 (Enabled).
When not using Software RAID, jumper setting to 1-2 (Disabled).
42
Important
If you use hard disk drives in the RAID system or change the RAID level,
initialize the hard disk drives. If the hard disk drive used in the RAID system
contains valuable data, be sure to backup the hard disk drive before installing
the RAID controller and configuring the RAID system.
Note
In the RAID system, use hard disk drives that have the same specifications
(capacity, rotational speed, and standard) for each disk array.
Tips
Logical drives can be created even with only one physical device.
Motherboard
Express5800/T110j User's Guide
1. Installing Internal Optional Devices
3 2 1 3 2 1
Enabled Disable
SWRAID