Setting The Parameters Of Setpoint Comparison - AND Weighing Indicator AD-4406 OP03 Instruction Manual

Toward the Zero band
Preliminary and Free fall output are holding the off state.
Over/Under comparison starts. If F23 is set to 30, judgment starts when Free fall turns
on. The judgment is not latched and the output is according to the state at the time.
The Weighing completion relay is turned on if F24 is set to 2. The on time is set by F25.
The READY mark is blinking regardless of the settings of F24 and F25.
Start is may be accepted at this state.
Returns to Zero band
Over/Under and Weighing completion output is off.
The READY mark is turned on.

11.2.3. Setting the Parameters of Setpoint Comparison

Refer to "11.1.2. Setting the Upper/Lower Limit Values".
Zero band value is set at F26 of the F-Functions, and the value does not belong
to a specific code memory, but is used commonly.
Setting Order and Display for Setpoint Comparison and Simple batch
F22 MODE
7 Setpoint
Comparison
8 Setpoint
Comparison
9 Setpoint
Comparison
10 Simple
Batch
11 Simple
Batch
12 Simple
Batch
AD-4406 Weighing Indicator
Display
Setpoint Final
Class
1 Comparator
Triangle
Setpoint Final
Class
2 Comparator
Triangle
Setpoint Final
Class
3 Comparator
Triangle
Setpoint Final
Class
1 Comparator
Triangle
Setpoint Final
Class
2 Comparator
Triangle
Setpoint Final
Class
3 Comparator
Triangle
1 2
Free fall
Fi FF
OK
1
Free fall
Fi FF
OK
1
Free fall
Fi FF
OK
1
Free fall
Fi FF
OK
1
Free fall
Fi FF
OK
1
Free fall
Fi FF
OK
1
Page 41
3 4
Over Under
Hi Lo
HI LO
Preliminary Over
Pr Hi
HI
2
Full Over
Fu Hi
HI
2
Over Under
Hi Lo
HI LO
Preliminary Over
Pr Hi
HI
2
Full Over
Fu Hi
HI
2
11.2. Setpoint Comparison
5
Under
Lo
LO
Under
Lo
LO
Under
Lo
LO
Under
Lo
LO