Gravity Compensation Function - AND Weighing Indicator AD-4406 OP03 Instruction Manual

5.5. Gravity Compensation Function

If the scale is used at the calibration location, it is not necessary to perform this function.
If there is a difference in the gravity acceleration between the calibration location
and the installed location, it may cause a weighing error. This function specifies
these gravity accelerations and corrects the span error.
Note The decimal point is not displayed in the function. Example: 9798 = 9.798 m/s
When span calibration is executed, the gravity acceleration correction will
be cleared and two gravity acceleration values will return to the factory
settings.
Step 1 At the CAL 0 display, press the
ENTER key to enter the gravity compensation function.
If you want to cancel the current procedure, press and hold the ON/OFF key and
press the ESC key to display CAnCEL. Then, no parameters are changed and the
calibration mode is finished. Press the ON/OFF key to turn the display off.
Step 2 The parameter is displayed with triangle 1. Enter the gravity acceleration of the
calibration location. The parameter xxxx is the gravity acceleration.
key....... To select a digit.
key ....... To select a value.
key .. To store the new gravity acceleration and proceed to step 3.
ENTER
key....... To return to G SEt without changing the value.
ESC
Step 3 The parameter is displayed with triangle 2. Enter the gravity acceleration of the
installed location. The parameter xxxx is the gravity acceleration.
key ...... To select a digit.
key....... To select a value.
ENTER key . To store the new gravity acceleration and proceed to step 4.
ESC key ...... To return to step 2 without changing the value.
Step 4 Now G xxxx is displayed. Press the CAL key to store the parameters. CALoFF is
displayed. Proceed to step 5.
Step 5 Press the ON/OFF key to turn the display off.
5.5. Gravity Compensation Function
key until G SEt is displayed and press the
Page 18
AD-4406 Weighing Indicator
2