Condition Formula For Comparison; Setting The Upper/Lower Limit Values - AND Weighing Indicator AD-4406 OP03 Instruction Manual

11.1.1. Condition Formula for Comparison

Comparison is performed based on the following formula.
Upper/lower limit comparison
Judge
HI
OK
LO
5-stage comparison
Judge
HiHi
HI
OK
LO
LoLo
The decimal point is ignored. Example: If the upper limit value is 10.0, enter 100.
These parameters are stored in non-volatile memory, and are not lost even if
power is turned off or the batteries are depleted.
When the displayed value becomes an overload (positive over), HI (over) is output.
When the displayed value becomes an under load (negative over), LO (under) is
output.
This function compares the upper limit value first.
This function does not check the relationship between the upper and lower limit
values.

11.1.2. Setting the Upper/Lower Limit Values

Step 1 Press and hold the setpoint setting function key, that function is activated. When
SEt Pt appears, release the key switch. The indicator enters the setpoint setting
mode and the display code memory number blinks.
Step 2 Set the code memory number using the following keys.
key..... To select a comparison class and proceed to step 3.
key ..... To select a code memory number.
ESC key To return to the weight display without changing code memory.
ENTER key To set the displayed code memory's setpoint and return to the
AD-4406 Weighing Indicator
Condition Formula
Upper limit (Hi limit) value < Displayed value
Lower limit value Displayed value Upper limit
Displayed value < Lower limit (Lo limit) value
Condition Formula
HiHi limit value < Displayed value
Upper limit (Hi limit) value < Displayed value
Lower limit value Displayed value Upper limit
Displayed value < Lower limit (Lo limit) value
Displayed value < LoLo limit value
weight display.
value
value
Page 37
Display Output
HI HI
OK OK
LO LO
Display Output
HI, 2 HI
HI HI, OK
OK OK
LO LO, OK
LO, 3 LO
11.1. Weight Check Mode