Setpoint Setting; Setting Using Key Switches - AND AD-4401A Instruction Manual

17. SETPOINT SETTING

Set setpoint values for batch weighing and check weighing.
Select a setpoint setting method (SP F-01) from the following.
- Key switches, RS-232C or RS-422/485 (Setpoint input not used)
- 5-digit input from external devices
- 16-digit input from external devices
Refer to "14. RS-422/485" for the setting procedure of the RS-232C or RS-422/485.
Refer to "11. SETPOINT INPUT" for the setting procedure using 5-digit or 16 digit input from external
devices.

17.1. Setting Using Key Switches

Operation
Normal mode
SETPOINT key
Item selection
ENTER key
TARE key
ZERO key
ON/OFF key
Setpoint input
ENTER key
TARE key
ZERO key
NET/GROSS key
Function key
ON/OFF key
Goes to the item selection mode.
Selects the blinking item in the lower status display and goes to the inputting
mode of the item.
Shifts the blinking item in the lower status display to the right.
Shifts the blinking item in the lower status display to the left.
Returns to the normal mode.
Saves the setpoint and returns to the item selection mode.
Shifts the blinking digit to the right.
Shifts the blinking digit to the left.
Increases the blinking digit by one.
Decreases the blinking digit by one.
Cancels the setpoint and returns to the item selection mode.
Page 61 AD-4401A