Fan Module Status Leds; Remove A Fan Module - Fujitsu SPARC Enterprise T5220 Service Manual

Fan Module Status LEDs

Each fan module contains a pair of LEDs, which are visible when you open the fan
compartment access door. The following table describes the status LEDs located on
the fan modules.
Fan Module Status LEDs
TABLE:
LED
Power OK
Service Required
The front and rear panel Service Required LEDs are also lit if the system detects a fan
module fault.
If the fan fault causes an over temperature condition to occur, the system Overtemp
LED will turn on and an error message will be logged as well as displayed on the
system console.
Related Information
"Front Panel Controls and Indicators on SPARC Enterprise T5120 Servers" on
■
page 5
"Rear Panel Components and Indicators on SPARC Enterprise T5120 Servers" on
■
page 8
"Front Panel Controls and Indicators on SPARC Enterprise T5220 Servers" on
■
page 9
"Rear Panel Components and Indicators on SPARC Enterprise T5220 Servers" on
■
page 12

▼ Remove a Fan Module

Caution – When changing the fan modules, remove only the fan modules. Do not
service any other components in the fan compartment unless all power is removed
from the system, including removing the power cords.
Color Notes
Green This LED is lit when the system is powered on
and the fan module is functioning correctly.
Amber This LED is lit when the fan module is faulty.
In addition, the system Fan Fault LED is lit.
Servicing Fan Modules 125