Fujitsu SPARC Enterprise T5220 Service Manual page 101

4. At the Solaris prompt, type the cfgadm -al command. This will list all drives
in the device tree, including drives that are not configured.
# cfgadm -al
This command should identify the Ap_id for the hard drive you plan to remove,
as shown below.
Ap_id
c0
c0::dsk/c1t0d0
c0::sd1
usb0/1
usb0/2
usb0/3
usb1/1
usb1/2
usb1/3
usb2/1
usb2/2
usb2/3
usb2/4
usb2/5
usb2/6
usb2/7
usb2/8
----------------------------
5. Type cfgadm -c configure command to configure the disk.
For example, the following shows drive c0:dsk/c1t1d1 being configured:
# cfgadm -c configure c0::sd1
where c0::sd1 is the disk that you want to configure.
6. Wait until the blue Ready-to-Remove LED is no longer lit on the drive that you
installed.
Type Receptacle
scsi-bus connected
disk connected
disk connected
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
unknown empty
Occupant Condition
configured unknown
configured unknown
unconfigured unknown
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
unconfigured ok
Servicing Hard Drives 75