If either of these conditions exist, you must power off the server before replacing a
hard drive.
Related Information
"Removing Power From the System" on page 60
■
"Power Off the Server (Service Processor Command)" on page 60
■
"Power Off the Server (Power Button - Graceful)" on page 62
■
"Four-Drive Capable Backplane Configuration Reference" on page 77
■
"Eight-Drive Capable Backplane Configuration Reference" on page 78
■
"Sixteen-Drive Capable Backplane Configuration Reference" on page 79
■
Hard Drive LEDs
Each hard drive has a group of three status LEDs, as shown in the following figure.
Both disk-based hard drives and flash SSDs use the same set of LEDS.
Note – The OK/Activity LED has slightly different behavior for SSDs than for
disk-based drives. This difference is described in the table that follows the figure.
FIGURE:
70
SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
Hard Drive LEDs