Fujitsu SPARC Enterprise T5220 Service Manual page 46

Diagnostic Flowchart Reference Table (Continued)
TABLE:
Diagnostic Action Possible Outcome
Check if the fault is Determine if the fault is an environmental fault or a
environmental. configuration fault.
(Flowchart item 6) If the fault listed by the show faulty command
displays a temperature or voltage fault, then the fault is
an environmental fault. Environmental faults can be
caused by faulty FRUs (power supply or fan), or by
environmental conditions such as when computer room
ambient temperature is too high, or the server airflow is
blocked. When the environmental condition is corrected,
the fault will automatically clear.
If the fault indicates that a fan or power supply is bad,
you can perform a hot-swap of the FRU. You can also
use the fault LEDs on the server to identify the faulty
FRU (fans and power supplies).
Determine if the If the fault displayed included a uuid and sunw-msg-id
fault was detected property, the fault was detected by the Solaris Predictive
by PSH. Self-Healing software.
(Flowchart item 7) If the fault is a PSH detected fault, refer to the PSH
Knowledge Article web site for additional information.
The Knowledge Article for the fault is located at the
following link:
(http://www.sun.com/msg/message-ID)
where message-ID is the value of the sunw-msg-id
property displayed by the show faulty command.
After the FRU is replaced, perform the procedure to
clear PSH detected faults.
Determine if the POST performs basic tests of the server components and
fault was detected reports faulty FRUs. When POST detects a faulty FRU, it
by POST. logs the fault and if possible, takes the FRU offline.
POST detected FRUs display the following text in the
(Flowchart item 8)
fault message:
Forced fail reason
In a POST fault message, reason is the name of the
power-on routine that detected the failure.
Contact technical The majority of hardware faults are detected by the
support. server's diagnostics. In rare cases a problem might
require additional troubleshooting. If you are unable to
(Flowchart item 9)
determine the cause of the problem, contact your service
representative for support.
20 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
Additional Information
• "Faults Displayed by show
faulty" on page 29
• "Managing Faults Using the
PSH Feature" on page 43
• "Clear PSH-Detected
Faults" on page 47
• "Detecting Faults With
POST" on page 34
• "Clear POST-Detected
Faults" on page 41