Technology; Clear Fru Faults Manually - Fujitsu SPARC Enterprise T5220 Service Manual

PSH Technology
-> show faulty
Target
--------------------+------------------------+-------------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
Related Information
"Clear FRU Faults Manually" on page 31
■
"Display FRU Information With the show Command" on page 32
■

▼ Clear FRU Faults Manually

Use the clear_fault_action property of a FRU to manually clear faults recorded
in a FRU PROM. There are two conditions where this step may be needed:
To clear a fault diagnosed by the predictive self-healing feature without replacing
■
the faulty FRU.
To clear a fault that the service processor was unable to clear following a FRU
■
replacement.
Note – This procedure clears the fault from the service processor but not from the
host. If the fault persists in the host, it must be manually cleared.
●
At the -> prompt, enter the clear_fault_action property.
-> set /SYS/MB/CMP0/BR0/CH0/D0 clear_fault_action=True
Are you sure you want to clear /SYS/MB/CMP0/BR0/CH0/D0 (y/n)? y
Set 'clear_fault_action' to 'true'
Related Info
"Clear PSH-Detected Faults" on page 47
■
| Property
| fru
| timestamp
| sunw-msg-id
|
| uuid
|
| timestamp
|
| Value
| /SYS/MB/CMP0/BR0/CH1/D0
| Dec 14 22:43:59
| SUN4V-8000-DX
|
| 3aa7c854-9667-e176-efe5-e487e520
| 7a8a
| Dec 14 22:43:59
|
Detecting and Managing Faults 31