Fujitsu SPARC Enterprise T5220 Service Manual page 66

-----------------------------------------------------------------
2007-12-19 22:01:32.004 0:0:0>End
Port 3
2007-12-19 22:01:32.012 0:0:0>INFO:
2007-12-19 22:01:32.019 0:0:0>POST Passed all devices.
2007-12-19 22:01:32.028 0:0:0>POST:Return to VBSC.
2007-12-19 22:01:32.036 0:0:0>Master set ACK for vbsc runpost
command and spin...
-----------------------------------------------------------------
T5220, No Keyboard
OpenBoot ..., 7968 MB memory available, Serial #75916434.
[stacie obp #0]
Ethernet address 0:14:4f:86:64:92, Host ID: xxxxx
{0} ok
4. If POST detects a faulty device, information about the device will be passed to
the service processor for handling. Fault information will also be displayed.
Note – If POST does not detect a fault, the system will boot. In this case, the problem
being investigated probably falls outside the scope of POST's test coverage. POST's
failure to detect any faults should be considered diagnostic data as well.
5. Evaluate the test information returned by POST.
See
in POST fault reporting.
6. Run the ILOM show faulty command to obtain additional fault information.
If show faulty detects a fault, the service processor logs the fault, disables the
faulty component and causes the Service Required LED to light. In the following
example, FB-DIMM module /SYS/MB/CMP0/BR1/CH0/D0 is disabled.
-> show faulty
Target
----------------------+------------------------+-----------------------------
/SP/faultmgmt/0
/SP/faultmgmt/0
/SP/faultmgmt/0/
faults/0
/SP/faultmgmt/0/
faults/0
40 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
"POST Output Quick Reference" on page 42
| Property
| fru
| timestamp
| timestamp
|
| sp_detected_fault
|
: Neptune 1G Loopback Test -
for a summary of the syntax used
| Value
| /SYS/MB/CMP0/BR1/CH0/D0
| Dec 21 16:40:56
| Dec 21 16:40:56
|
| /SYS/MB/CMP0/BR1/CH0/D0
| Forced fail(POST)