Fujitsu SPARC Enterprise T5220 Service Manual page 100

Note – SPARC Enterprise T5120 servers might have up to seven blank panels
covering unoccupied drive slots. SPARC Enterprise T5220 servers might have as
many as fifteen blank panels covering unoccupied hard drive slots.
2. Align the replacement drive to the drive slot.
Hard drives are physically addressed according to the slot in which they are
installed. If you install a hard drive as a replacement for a drive that was removed,
the new drive must go into the same slot as the drive it is replacing.
FIGURE:
3. With the latch open, slide the hard drive into its bay until it is fully seated.
Then close the latch to secure the drive.
74 SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
Installing a Hard Drive (Illustrating Installation in a SPARC Enterprise T5220
Server)