6. If you are installing a new motherboard, install the following components:
a. All FB-DIMMs removed from the previous motherboard. Ensure that the
b. SCC module. See
7. Connect the hard drive data cables. For cable routing instructions, see
whichever of the following topics apply:
■
■
8. Install the air duct.
See
9. Reinstall the motherboard-to-power distribution board ribbon cable.
10. Reinstall the PCIe and XUAI risers.
See
11. Install the top cover.
See
12. Install the server into the rack.
See
13. Attach the power cables.
See
14. Power on the server.
See
On the Server Using the Front Panel Power Button" on page
Related Information
"Remove the Motherboard Assembly" on page 118
■
122
SPARC Enterprise T5120 and T5220 Servers Service Manual • July 2009
FB-DIMM modules are installed in the same memory configuration as they
were in before.
See
"FB-DIMM Configuration Guidelines" on page
"SCC Module Overview" on page
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5120
Servers" on page 188
"Internal Cables for Onboard SAS Controller Cards in SPARC Enterprise T5220
Servers" on page 202
"Install the Air Duct" on page 101
"Install a PCIe/XAUI Riser" on page
"Install the Top Cover" on page
"Reinstall the Server in the Rack" on page
"Connect Power Cords to the Server" on page
"Power On the Server Using the poweron Command" on page 179
95.
114.
.
104.
175.
176.
178.
or
"Power
180.