Step 3
Converting to Line Image
1
Move to line image: Click
also click the button of the Toolbar shown below:
NOTE: Many menu functions can be activated by clicking a button on the Toolbar.
The
Cut out to Line Image
used to make the outline of the image.
2
When you click
on the menu bar, then click
Stage
dialog will display. In this dialog, you will select the color(s) that will be
, the line image displays.
OK
To Line Image
To Line Image
N If necessary, scroll and zoom the image.
N Move the cursor over the image. Its shape
changes to
. Click on any point of the out-
line. The selected color displays in the upper
box under
Pick Colors
check box to show that the color is selected.
•
When the outline of the image uses more than one
color, you can repeat to select a total of five colors.
If you try to select more, colors are scrolled down,
and the color that was at the bottom is deselected.
•
If you selected a color by mistake, simply click
its check box to deselect it.
N Click
to see the effect of your selection.
View
•
If you wanted to select another choice of color,
click
. The image displays again and you
Cancel
can repeat this step with another color.
N If your preview image looks like the one shown
here, click
to confirm the outline of your pattern.
OK
N Click
to exit and go back to the image.
Cancel
N If necessary, click
Image Tune
ors or the noise. (page 109)
•
At this stage, the data can be saved as a
file.
on the submenu. You can
and a
appears in the
to reduce the col-
*.pel
19