Table of Contents
Advertisement
If Auto Punch is selected:
1
After the image characteristics are analyzed, a dialog similar to the one shown below appears.
2
Select the areas that are to be sewn.
In the image on the
pattern.
Click in the areas to specify whether or not they will be sewn.
182
tab, areas not set to be sewn are shown filled with a crosshatch
Result View
N Click the
Result View
resulting analyzed image. The embroi-
dery data will be created with this
image.
N Click the
Original View
original image.
N Drag the
ratio that the image is displayed in.
N Select the
Show Outline
display the outline extracted from the
analyzed image.
N Select the desired image-analyzing set-
tings under Analysis Parameters.
Noise reduction:
that is removed from the image.
Segmentation sensitivity:
smoothness of the extracted outline.
Outline smoothness:
ness of the extracted outline.
Max. Number of colors:
ber of colors used.
After the necessary settings are
selected, click
image. If
Retry
settings are not applied.
Thread Chart:
for selecting the thread color. The most
appropriate thread color from the
selected thread chart is selected. A
user thread chart can also be selected.
These areas will not be sewn
tab to display the
tab to display the
slider to adjust the zoom
check box to
Sets the level of noise
Sets the
Sets the smooth-
Sets the num-
to re-analyze the
Retry
is not clicked, the new
Selects the thread chart
Advertisement
Table of Contents
