Junos 10.3 OS Release Notes
Changes in Default Behavior and Syntax in Junos OS Release 10.3 for J-EX Series Ethernet
Switches
Related
Documentation
Limitations in Junos OS Release 10.3 for J-EX Series Ethernet Switches
54
Outstanding Issues in Junos OS Release 10.3 for J-EX Series Ethernet switches on
page 57
Resolved Issues in Junos OS Release 10.3 for J-EX Series Ethernet switches on page 60
Errata in Documentation for Junos OS Release 10.3 for J-EX Series Ethernet switches
on page 63
Interfaces
The default for the PoE management mode has been changed from static mode to
class mode.
New Features in Junos OS Release 10.3 for J-EX Series Ethernet switches on page 52
Limitations in Junos OS Release 10.3 for J-EX Series Ethernet switches on page 54
Outstanding Issues in Junos OS Release 10.3 for J-EX Series Ethernet switches on
page 57
Resolved Issues in Junos OS Release 10.3 for J-EX Series Ethernet switches on page 60
Errata in Documentation for Junos OS Release 10.3 for J-EX Series Ethernet switches
on page 63
This section lists the limitations in Junos OS Release 10.3R2 for J-EX Series Ethernet
switches.
Access Control and Port Security
When you have configured more than 1024 supplicants on a single interface, 802.1X
authentication might not work as expected and the 802.1X process (
The RADIUS request sent by a J-EX Series Ethernet switch contains both Extensible
Authentication Protocol (EAP) Identity Response and State attributes.
When an external RADIUS server goes offline and comes back online after some time,
subsequent captive portal authentication requests might fail until the
is restarted. As a workaround, configure the revert interval—the time after which to
revert to the primary server—and restart the
Bridging, VLANs, and Spanning Trees
On J-EX Series Ethernet switches, configuring more than 64,000 MAC address clone
routes in a single VLAN causes the Routing Engine to create core files and reboot.
Class of Service
On J-EX8200 switches, classification of packets using ingress firewall filter rules with
forwarding-class and loss-priority configurations does not rewrite the DSCP or 802.1p
dot1xd
daemon.
authd
) might fail.
daemon
authd