Dell PowerConnect J-8208 Release Note page 33

On J-SRX Series devices, the software upload and install package will not show a
warning message when there are pending changes to be committed. [PR/514853]
On J-SRX240 Low Memory devices, the LSQ interface transmitting both LLQ and
non-LLQ traffic drops out-of-profile packets of the LLQ traffic faster than it was
dropping them out earlier. [PR/536588]
On J-SRX240 High Memory devices under continuous high HTTP traffic load, the
forwarding daemon might generate a core file. This core file might be seen after more
than 24 hours of continuous high load. Forwarding restarts when the forwarding core
file is generated; then the device functions normally. [PR/538383]
Hardware
On J-SRX210 devices, the MTU size is limited to 1518 bytes for the 1-port SFP Mini-PIM.
[PR/296498]
On J-SRX240 devices, the Mini-PIM LEDs glow red for a short duration (1 second) when
the device is powered on. [PR/429942]
On J-SRX240 devices, the file installation fails on the right USB slot when both of the
USB slots have USB storage devices attached. [PR/437563]
On J-SRX240 devices, the combinations of Mini-PIMs cause SFP-Copper links to go
down in some instances during bootup, restarting fwdd, and restarting chassisd. As a
workaround, reboot the device and the link will be up. [PR/437788]
Interfaces and Routing
On J-SRX240 devices, when you are configuring the link options on an interface, only
the following scenarios are supported:
Autonegotiation is enabled on both sides.
Autonegotiation is disabled on both sides (forced speed), and both sides are set to
the same speed and duplex.
If one side is set to autonegotiation mode and the other side is set to forced speed,
the behavior is indeterminate and not supported. [PR/423632]
On J-SRX Series devices, the RPM operation will not work for the probe-type tcp-ping
when the probe is configured with the option
On J-SRX Series devices, incorrect Layer 2 circuit replication on the backup Routing
Engine might occur when you:
Configure nonstop active routing (NSR) and Layer 2 circuit standby simultaneously
and commit them
Delete the NSR configuration and then add the configuration back when both the
NSR and Layer 2 circuits are up
As a workaround:
Configure the Layer 2 circuit for a nonstandby connection.
1.
Change the configuration to a standby connection.
2.
Issues in Junos OS Release 10.3 for J-SRX Series Services Gateways
destination-interface
. [PR/424925]
33