Outstanding Issues In Junos Os Release 10.3 For J-Srx Series Services Gateways - Dell PowerConnect J-8208 Release Note

Release notes junos version 10.3
Hide thumbs Also See for PowerConnect J-8208:
Table of Contents

Advertisement

Junos 10.3 OS Release Notes
30

Outstanding Issues In Junos OS Release 10.3 for J-SRX Series Services Gateways

The following problems currently exist in J-SRX Series devices. The identifier following
the description is the tracking number in our bug database.
Application Layer Gateways (ALGs)
On J-SRX210 devices, the SCCP call cannot be set up after disabling and enabling the
SCCP ALG. The call does not go through. [PR/409586]
On J-SRX240 devices, the maximum SCCP calls cannot be made under stress
conditions. [PR/490839]
On J-SRX Series devices, SIP server protection does not work. The
application-screen protect deny
AX411 Access Point
On J-SRX210 PoE devices, the access point reboots when 100 clients are associated
simultaneously and each one is transmitting 512 bytes packets at 100 pps. [PR/469418]
Chassis Cluster
On J-SRX Series devices in a chassis cluster, configuring the
jsrp-service disable
command only on the primary node causes the cluster to go into
an incorrect state. [PR/292411]
On J-SRX Series devices in a chassis cluster, using the
chassis-control disable
device to crash. Do not use this command on a J-SRX Series device in a chassis cluster.
[PR/296022]
On a J-SRX210 device in a chassis cluster, when you upgrade the nodes, sometimes
the forwarding process might crash and get restarted. [PR/396728]
On a J-SRX210 device in a chassis cluster, sometimes the
might not make it to the switch filter table. This results in the dropping of traffic sent
to the
interface. As a workaround, restart the Packet Forwarding Engine.
reth
[PR/401139]
On a J-SRX210 device in a chassis cluster, the fabric monitoring option is enabled by
default. This can cause one of the nodes to move to a disabled state. You can disable
fabric monitoring by using the following CLI command:
set chassis cluster fabric-monitoring disable
[PR/404866]
On a J-SRX210 Low Memory device in a chassis cluster, the firewall filter does not work
on the
interfaces. [PR/407336]
reth
On a J-SRX210 device in a chassis cluster, the restart forwarding method is not
recommended because when the control link goes through forwarding, the restart
forwarding process causes disruption in the control traffic. [PR/408436]
On a J-SRX210 device with an FTP session ramp-up rate of 70, either of the following
might disable the secondary node:
command does not work. [PR/512202]
command for 4 to 5 minutes and then enabling it causes the
set security alg sip
set system process
set system processes
interface MAC address
reth

Advertisement

Table of Contents
loading

Table of Contents