Dell PowerConnect J-8208 Release Note page 34

Junos 10.3 OS Release Notes
34
Add the NSR configuration.
3.
[PR/440743]
On J-SRX210 Low Memory devices, the E1 interface will flap and traffic will not pass
through the interface if you restart forwarding while traffic is passing through the
interface. [PR/441312]
On J-SRX240 Low Memory devices and J-SRX240 High Memory devices, the RPM
Server operation does not work when the probe is configured with the option
. [PR/450266]
destination-interface
On J-SRX210 PoE devices, the ATM interface on G.SHDSL interface will not go down
when the interface is disabled through the
On J-SRX210 devices, the modem moves to the dial-out pending state while connecting
or disconnecting the call. [PR/454996]
On J-SRX100, and J-SRX210 devices, out-of-band dial-in access using a serial modem
does not work. [PR/458114]
On J-SRX100 devices with VDLS2, multiple carrier transitions (three to four) are seen
during long duration traffic testing with ALU 7302 DSLAM. There is no impact on traffic
except for the packet loss after long duration traffic testing, which is also seen in the
vendor CPE. [PR/467912]
On J-SRX210 devices with VDLS2, remote end ping fails to go above the packet size
of 1480 as the packets are get dropped for the default MTU which is 1496 on an
interface and the default MTU of the remote host ethernet intf is 1514. [PR/469651]
On J-SRX210 devices, the G.SHDSL ATM logical interface goes down when ATM CoS
is enabled on the interface with OAM. As a workaround, restart the FPC to bring up the
logical interface. [PR/472198]
On J-SRX210 devices with VDLS2, ATM COS VBR related functionality cannot be tested
because of lack of support from the vendor. [PR/474297]
On J-SRX210 High Memory devices, IGMP v2 JOINS messages are dropped on an IRB
interface. As a workaround, enable IGMP snooping to use IGMP over IRB interfaces.
[PR/492564]
On J-SRX210 devices, every time the VDSL2 PIM is restarted in the ADSL mode, the
first packet passing through the PIM will be dropped. This occurs because there is a
bug in the SAR engine, which will not set the ATM connection until the first packet has
been dropped because of no ATM connection. [PR/493099]
On all J-SRX Series devices, the destination and destination-profile options for address
and unnumbered-address within family inet and inet6 are allowed to be specified
within a dynamic profile but not supported. [PR/493279]
On J-SRX210-High Memory devices, the physical interface module (PIM) shows time
in ADSL2+ ANNEX-M, even though it is configured for ANNEX-M ADSL2. [PR/497129]
On J-SRX100, J-SRX210, and J-SRX240 devices, whenever
under profile option radius server is marked as dead permanently if radius times out.
disable command. [PR/453896]
radius-server
is configured