Dell PowerConnect J-8208 Release Note page 37

ports to a maximum power of 12.4 watts. Use the following command to configure the
ports:
root#
set poe interface all maximum-power 12.4
[PR/465307]
On J-SRX100, J-SRX210, and J-SRX240 devices with factory default configurations,
the device is not able to manage the AX411 Access Point. This might be due to the
DHCP default gateway not being set. [PR/468090]
On J-SRX210 PoE devices managing AX411 Access Points, traffic of 64 bytes at speed
more than 45 megabits per second (Mbps), might result in loss of keepalives and
reboot of the AX411 Access Point. [PR/471357]
On J-SRX210 PoE devices, high latencies might be observed for the Internet Control
Message Protocol (ICMP) pings between two wireless clients when 32 virtual access
points (VAPs) are configured. [PR/472131]
On J-SRX210 PoE devices, when AX411 Access Points managed by the J-SRX Series
devices reboot, the configuration might not be reflected onto the AX411 Access Points.
As a result, the AX411 Access Points retain the factory default configuration.
[PR/476850]
Security
On J-SRX210, if the Infranet Controller auth table mapping action is configured as
provision auth table as needed
Engine failover. You might have to initiate new sessions. Existing sessions will not get
affected after Routing Engine failover if the Infranet Controller auth table mapping
action is configured as
always provision auth table
Unified Threat Management (UTM)
On J-SRX210 High Memory devices, content filtering provides the ability to block protocol
commands. In some cases, blocking these commands interferes with protocol
continuity, causing the session to hang. For instance, blocking the
for the IMAP protocol causes the client to hang without receiving any response.
[PR/303584]
On J-SRX210 High Memory devices, when the content filtering message type is set to
protocol-only , customized messages appear in the log file. [PR/403602]
On J-SRX210 High Memory devices, the express antivirus feature does not send a
replacement block message for HTTP upload (POST) transactions if the current
antivirus status is
engine-not-ready
empty file is generated on the HTTP server without any
it. [PR/412632]
On J-SRX240 devices, Outlook Express is sending infected mail (with an EICAR test
file) to the mail server (directly, not through DUT). Eudora 7 uses the IMAP protocol to
download this mail (through DUT). Mail retrieval is slow, and the EICAR test file is not
detected. [PR/424797]
On J-SRX240 High Memory devices, FTP download for large files (> 4 MB) does not
work in a two-device topology. [PR/435366]
Issues in Junos OS Release 10.3 for J-SRX Series Services Gateways
, UAC terminates the existing sessions after Routing
. [PR/416843]
and the fallback setting for this state is
block
command
FETCH
. An
block
message contained within
37