Kyocera FS C5020N - Color LED Printer Service Manual page 41

Service items
Items
Calibration information 2 (CT02 to CT09)
[I/O output data information]
Calibration information 3 (CT10 to CT13)
[Measure bias data information]
Calibration information 4 (CT14)
Calibration information 5 (CT15)
Calibration information 6 (CT16)
Engine parameter setting
Drum serial number
Machine serial number
Description
Each 2 bytes in the following order:
/99.6%/95%/85%/70%/55%/40%/27%/15%/
CT02: /S-wave background Magenta/
P-wave background Magenta/
CT03: /S-wave background Cyan/ P-wave background Cyan/
CT04: /S-wave background Yellow/ P-wave background Yellow/
CT05: /S-wave background Black/ P-wave background Black/
CT06: /S-wave patch Magenta/ P-wave patch Magenta/
CT07: /S-wave patch Cyan/ P-wave patch Cyan/
CT08: /S-wave patch Yellow/ P-wave patch Yellow/
CT09: /S-wave patch Black/ P-wave patch Black/
Each 2 bytes in the following order: /450V/400V/350V/Beta/
CT10: /S-wave background Magenta/
S-wave background Cyan/ S-wave background Yellow/
S-wave background Black/
CT11: /P-wave background Magenta/
P-wave background Cyan/ P-wave background Yellow
P-wave background Black/
CT12: /S-wave patch Magenta/ S-wave patch Cyan/
S-wave patch Yellow/ S-wave patch Black/
CT13: /P-wave patch Magenta/ P-wave patch Cyan/
P-wave patch Yellow/ P-wave patch Black/
/Background P-wave max. (2 bytes)/
Background P-wave min. (2 bytes)/
Developing bias data Magenta (1 byte)/
Developing bias data Cyan (1 byte)/
Developing bias data Yellow (1 byte)/
Developing bias data Black (1 byte)/
LED control voltage (2 bytes)/
Relative compensation for toner (2 bytes)
Each 2 bytes in the following order:
/Magenta 450/400/350/Beta/ Cyan 450/400/350/Beta/
Yellow 450/400/350/Beta/ Black 450/400/350/Beta/
/Total number of times/ Number of cancellation/
Number of retries/ E10 error/ E11 error/ E12 error/
1
Calibration result (IO)* / Calibration result (bias)*
1
* : E00: Completed normally.
E10: Sensor value does not proportionally increase.
E1X: Calibration sensor (Toner ID sensor) error
E11: Sensor value increases too few.
E12: Sensor value increases too few and does not increase
proportionally.
E20: Calibration cancelled from engine request.
2
* : B00: Completed normally.
All biases (C/M/Y/K) are within range of 0x8B - 0xE1.
B10: Bias sensor value error
One of the biases (C/M/Y/K) is less than 0x8A or more
than 0xE2.
16 ppm printer: Hexadecimal, 128 bytes (256 digits)
24 ppm printer: Hexadecimal, 256 bytes (512 digits)
/Black/Cyan/Magenta/Yellow/
-
Description
2
/
2F3/2F4-5
1-4-7