17. Pass the blue and white FFCs to opening of
the LED print head cover.
18. Store the FFCs in the crevice between LED
print head (metal) and sponge.
19. Close the LED print head cover and hold the
three hooks.
20 . Check that the press springs on both sides
of the LED print head are not buckling.
Note: If the press springs are buckling, push
down on the central part of the LED print
head cover to correct the buckle.
Figure 1-6-28
NG
OK
LED print head cover
Figure 1-6-29
2F3/2F4
1-6-19