Configuring The Ip Address Using Arp And Ping Commands - Canon imagePROGRAF iPF760 User Manual

Configuring the IP Address Using ARP and PING Commands

2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4
Press ▲ or ▼ to select TCP/IP, and then press the OK button.
5
Press ▲ or ▼ to select IPv4, and then press the OK button.
6
Press ▲ or ▼ to select IPv4 Settings, and then press the OK button.
7
Press ▲ or ▼ to select IP Address, and then press the OK button.
8
After you press ◀ or ▶ to select the input field, numerical input is possible.
9
Press the ▲ or ▼ button to enter the value.
•
•
Note
•
•
10
Repeat steps 8 and 9 to complete the settings, and then press the OK button.
11
Press the Menu button.
If you have changed the settings, a confirmation message is
displayed. Press ▲ or ▼ to select Yes, and then press the OK
button.
•
Be sure to complete step 11. This will activate the values you have entered.
•
If an error message is displayed, check the settings and correct any invalid values.
Important
•
You can also specify the subnet mask and default gateway on the Control Panel.
Note
Configuring the IP Address Using ARP and PING Commands Configuring the IP Address Using ARP and PING Commands
This topic describes how to configure the IP address using ARP and PING commands.
528
Pressing the ▲ button increases the number by 1. The maximum value is 9, after which 0 is displayed.
Pressing the ▼ button decreases the number by 1. The minimum value is 0, after which 9 is displayed.
Hold down ▲ or ▼ to increase or decrease the value continuously.
Make sure the IP address you enter for the printer is not the same as any computer IP address in your network.
iPF760
User's Guide