Table of Contents
Advertisement
12 EN
| GripAdjustment
I
Adjust the velcro strip.
2 Passyour right hand through the loop and grasp
the grip.
3 Adjust your thumb and fingers through the grip to
easily operate the Recording Start/Stop Button,
Power Switch and Power Zoom Lever, Be sure to
fasten the velcro strip to your preference.
• Some tripods are not equipped with studs.
| Viewfinder Adjustment
1
set the Power Switch to "1_1"or "[_" while
pressing down the Lock Button located on the
switch.
2 Pull out the viewfinder
fully and adjust it
manually for best viewability.
3 Turn the Diopter Adjustment Control until the
indications in the viewfinder are clearly focused,
O
Diopter Adjustment
Control
| Tripod Mounting
To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise.
CAUTION:
When attaching the camcorder to a tripod, extend
its legs to stabilize the camcorder. It is not advised
to use small sized tripods. This may cause damage
to the unit by falling over.
| LCD Monitor A ndViewfinder
While using the LCD monitor:
Make sure the viewfinder is pushed back in. Press
PUSH OPEN and open the LCD monitor fully. It can
rotate 270 " (90 ° downward,
180° upward).
While using the viewfinder:
Make sure the LCD monitor is closed and locked.
Pull out the viewfinder fully.
• Be sure to pull out the viewfinder
until you hear a
chck, otherwise it may be pushed back in during
use.
PUSH OPEN Button
NOTES:
• The image will not appear simultaneously
on the
LCD monitor and the viewfinder. When the
viewfinder is pulled out while the LCD monitor is
opened, you can select which one to use. Set
"PRIORITY" to the desired mode in SYSTEM
Menu. (:-z,pg. 3 I, .38)
• Colored bright spots may appear all over the LCD
monitor or the viewfinder.
However, this is not a
malfunction.
I__ pg. 73)
Advertisement
Table of Contents
