Dell PowerEdge VRTX Reference Manual page 45

Example
Output
The getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the
output is displayed in the following format:
•
chassis
: default state if -m is not specified
•
server-n
: where n = 1 to 4
•
switch-n
: where n = 1
getniccfg NIC Enabled= 1
IPv4 Enabled = 1
DHCP Enabled = 1
Static IP Address = 192.168.0.120
Static Subnet Mask = 255.255.255.0
Static Gateway = 192.168.0.1
Current IP Address = 10.36.1.78
Current Subnet Mask = 255.255.254.0
Current Gateway = 10.36.0.1
IPv6 Enabled = 0
Autoconfiguration Enabled = 1
Static IPv6 Address = ::/64
Static IPv6 Gateway = ::
Link Local Address = ::
Current IPv6 Address 1 = ::
Current IPv6 Gateway = ::
Speed = Autonegotiate
Duplex = Autonegotiate
VLAN Enable = 0
VLAN ID = 1
VLAN priority = 0
45