Insufficient Paper For Job; This Paper Cannot Be Used; Roll Printing Is Selected - Canon imagePROGRAF iPF650 User Manual

Insufficient paper for job

The printer has received a print job longer than the amount of roll paper
left when ManageRemainRoll in the Control Panel menu is On.

This paper cannot be used.

Cause
Paper smaller than the printer's minimum suppor-
ted size has been loaded.
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle
checking.

Roll printing is selected.

Cause
You have attempted to print a test print sheet
or other printer status information on a roll,
but no roll is loaded.
iPF650
Cause
Push the Release Lever back and load paper of the correct size.
(See "Paper Sizes.")
Push the Release Lever back and load unused paper of A4 size or
larger. More than one sheet may be required depending on the ad-
justment.
Press ▲ or ▼ to select Load Roll Paper, and then press the OK but-
ton. Load the roll, and then print.
(See "Attaching the Roll Holder to Rolls.")
(See "Loading Rolls in the Printer.")
To print on sheets, follow these steps.
1. Press ▲ or ▼ to select Stop Printing, and then press the OK but-
ton to stop printing.
2. Load a sheet and try printing again.
(See "Loading and Printing on Sheets.")
Error Message > Messages regarding paper
Corrective Action
Press ▲ or ▼ to select Print, and then
press the OK button to resume printing.
However, the roll paper may run out during
the print job and you may not be able to
print all of the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button to stop printing.
Either change the printer driver Paper
Source setting or the GL2 Settings > Pa-
per Source setting in the printer menu or
replace the roll with a roll that has enough
paper for the print job, and then try printing
again.
(See "Removing the Roll from the Print-
er.")
→P.578
(See "Loading Rolls in the Printer.")
→P.572
Corrective Action
→P.565
Corrective Action
→P.568
→P.572
→P.6
Insufficient paper for job
>
12
799