Paper Size Not Detected - Canon imagePROGRAF iPF650 User Manual

Error Message >
When Detect Mismatch in the Control Panel menu
is set to Pause or Warning, the width of the loa-
ded roll does not match the width specified in Fit
Roll Paper Width in the printer driver.

Paper size not detected.

Paper has been loaded askew, or warped paper has been loaded.
12
798
Because the Platen is soiled with ink or other substances, the size of
the clear film cannot be detected.
Paper size not detected.
Messages regarding paper >
Cause
Cause
Corrective Action
Make sure the roll width selected in the dialog box displayed
when you select Fit Roll Paper Width in the printer driver
matches the width of the roll loaded in the printer, and then try
printing again.
Follow these steps to reload the roll.
1. Push the Release Lever back.
2. Adjust the right edge of the roll to make it
parallel to the orange Paper Alignment Line.
3. Pull the Release Lever forward.
4. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
(See "Loading Rolls in the Printer.")
→P.572
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push the
roll firmly in until it touches the Roll Holder
flange, and reload the Roll Holder in the print-
er.
(See "Attaching the Roll Holder to Rolls.")
→P.568
Follow these step to reload a sheet.
1. Push the Release Lever back.
2. Load the sheet, aligning it with the guide on
the right.
3. Pull the Release Lever forward.
4. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page
on which the error occurred.
(See "Loading Sheets in the Printer.")
→P.594
Open the Top Cover and clean the entire Plat-
en.
(See "Cleaning Inside the Top Cover.")
→P.744
Corrective Action
iPF650