Configuring The Communication Mode Manually - Canon imagePROGRAF iPF650 User Manual

Item
Location
Administrator
Phone
Comments(E-mail)
Security Settings
Item
New Password Enter the new password.
(0-9999999)
Confirm Enter the new password again to confirm it.
(0-9999999)
On the Security settings screen, besides entering a password, you can specify other security-related information,
such as IP address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or IPP and
FTP authentication settings.
7.
Click OK to activate the settings.

Configuring the Communication Mode Manually

This topic gives instructions for configuring the communication mode manually.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.
5.
Press ▲ or ▼ to select Auto Detect, and then press the OK button.
iPF650
Details
Enter the location where the device is installed.
(0–32 characters)
Enter the administrator's name.
(0–32 characters)
Enter the administrator's contact information.
(0–32 characters)
Enter any comments regarding the administrator.
(0–32 characters)
Details
Network Setting
Default Setting
blank
blank
blank
blank
Default Setting
blank
blank
Configuring the Communication Mode Manually
> Network Setting >
9
).
697