Printing From A Desired Starting Point - Canon imagePROGRAF iPF650 User Manual

Handling Paper >

Printing From a Desired Starting Point

When printing inside boundaries or in other situations when you want to specify a particular position to start printing from,
set Width Detection to Off in the printer menu for the type of paper used.
Set Width Detection to Off
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Paper tab (
2.
Press the OK button.
The Paper Menu is displayed.
6
3.
Press ▲ or ▼ to select Paper Details, and then press the OK button.
4.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
5.
Press ▲ or ▼ to select Width Detection, and then press the OK button.
6.
Press ▲ or ▼ to select Off, and then press the OK button.
Load paper in the desired position to start printing from
Follow these instructions to load paper at the desired starting position for printing when Width Detection is Off.
1.
If you did not send a print job in advance, a menu for selection of the type of paper is displayed.
Press ▲ or ▼ to select the type of paper, and then press the OK button.
598
2.
"Width Detection OFF. OK to continue?" is now shown on the Display Screen. Press ▲ or ▼ to select "Leave
OFF", and then press the OK button.
3.
After a menu for selection of the paper size is displayed, press ▲ or ▼ to select the paper size, and then press the
OK button.
Printing From a Desired Starting Point
Handling sheets >
Note
• If the Tab Selection screen is not displayed, press the Menu button.
Note
• If a print job was received before paper was advanced, the media type and size specified by the job
are shown on the Display Screen.
Thus, this screen is not displayed. Go to step 2.
).
iPF650