Replacing Booklet Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Fuji Xerox ApeosPort-V C5575 Administrator's Manual

3 Maintenance
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6
With grasping the orange lever of the staple
cartridge, push the staple cartridge into its
original position until it clicks into place.
3
7
Close the finisher front door.
Note

Replacing Booklet Staple Cartridge (for Booklet Maker Unit for Finisher-B1)

When the Booklet Maker Unit for Finisher-B1 (optional) is installed and the booklet staple
cartridges need to be replaced, a message appears on the touch screen. When this message
appears, replace the booklet staple cartridges with new ones.
Important • The use of booklet staple cartridges not recommended by Fuji Xerox may degrade quality and
Note
1
Make sure that the machine is not operating,
and open the finisher side cover.
2
Hold the tabs on both sides of the booklet
staple cartridge and pull it out.
94
• If the front door is not closed completely, a message appears and the machine will remain paused.
performance. Use only booklet staple cartridges recommended by Fuji Xerox.
• To order a booklet staple cartridge, contact our Customer Support Center.
2
1