Table of Contents
Advertisement
4-6 Administrator's Handbook
Currently there is a restriction that the remote user must be routed to via the WAN interface, otherwise the
connections will fail. There is no restriction as to the number of connections.
There is no user configuration required for this feature.
MultiNAT Configuration
You configure the MultiNAT features through the Telnet menu:
•
For a simple 1-to-many NAT configuration (classic NAT or PAT), use the
described below.
•
For the more advanced features, such as server lists and dynamic NAT, follow the instructions in:
•
System
Configuration, described on
•
IP profile
parameters, described on
Easy Setup Profile configuration
The screen below is an example. Depending on the type of Router you are using, fields displayed in this screen
may vary.
Underlying Encapsulation...
PPP Mode...
PPP Authentication...
Send User Name:
Send Password:
Address Translation Enabled:
IP Addressing...
Local WAN IP Address:
Local WAN IP Mask:
Remote IP Address:
Remote IP Mask:
PREVIOUS SCREEN
Enter basic information about your WAN connection with this screen.
The Local WAN IP Address is used to configure a NAT public address range consisting of the Local WAN IP
Address and all its ports. The public address map list is named Easy-PAT List and the port map list is named
Easy-Servers.
The two map lists, Easy-PAT List and Easy-Servers, are created by default and NAT configuration becomes
effective.This will map all your private addresses (0.0.0.0 through 255.255.255.255) to your public address.
These map lists are bound to the Easy Setup Profile. See
This is all you need to do if you want to continue to use a single PAT, or 1-to-many, NAT configuration.
page 4-7
page 4-21
Connection Profile 1: Easy Setup Profile
tonyf
********************
Easy Setup Profile
None
VC Multiplexed
PAP
Yes
Numbered
0.0.0.0
0.0.0.0
127.0.0.2
255.255.255.255
NEXT SCREEN
Binding Map Lists and Server Lists on page
configuration,
4-21.
Advertisement
Table of Contents
