Table of Contents
Advertisement
a. Set Syslog Enabled to Yes
b. Set Hostname or IP Address to the Syslog Server
c. Facility... can be changed (default to Local 0)
d. Set Log Filter Violations to Yes - this will log packets that are dropped by the Router due to violations
e. Set Log Accepted Packets to Yes
f. Set Log Access Attempts to Yes
g. Escape twice to the Main Menu and go to Utilities and Diagnostics...
h. Select Restart System... and CONTINUE
Enable the Stateful Inspection Firewall
See
"Stateful Inspection" on page 3-3
1.
Go to System Confiuration..., Select Stateful Inspection...
a. UDP no-activity timeout (sec) can be adjusted.
b. TCP no-activity timeout (sec) can be adjusted.
c. Set DoS Detect to Yes
d. Escape twice to get to the Main Menu
2.
Go to WAN Configuration...
3.
Select Display/Change Connection Profile...
4.
Select Easy Setup Profile (if available) or the desired Connection Profile you have created.
5.
Go to IP Profile Parameters
6.
Under IP Profile Parameters, Set Stateful Inspection Enabled to Yes
7.
Select Stateful Inspection Options...
a. Under Stateful Inspection Parameters, configure Max. TCP Sequence Number Difference, if desired.
b. Set Enable default mapping to router to No
c. Deny Fragmented Packets can be set to Yes
8.
Escape twice to Change Connection Profile menu, select COMMIT
9.
Escape to the Main Menu and go to Utilities and Diagnostics...
10. Select Restart System... and CONTINUE
for more information.)
System Configuration 3-63
Advertisement
Table of Contents
