NEC Express5800 Series User Manual page 79

To remove a floppy disk from the drive, press the eject button.
CHECK:
Before removing a floppy disk, make sure that the floppy disk access LED is off. If you eject a
floppy disk while the LED is on, the stored data could be damaged.
Use of Floppy Disk
You may need to store important data on floppy disks. Since the floppy disk is a very delicate
medium, you must handle it with extra care:
Push the floppy disk gently into place.
Attach the label on a proper position.
Do not use a pencil or ballpoint pen to write on the floppy disk.
Do not open the protective shutter.
Do not use the floppy disk in a dusty place.
Do not place anything on the floppy disk.
Do not leave the floppy disk in a place that is subject to direct sunlight or high temperatures
(e.g., near a heater).
Keep away from cigarette smoke.
Do not leave the floppy disk near water or chemicals.
Keep away from magnetic objects.
Do not clip disks. Be careful not to drop.
Store floppy disks in a protective case where they are kept away from magnetic waves or
dust.
To prevent data from being erased accidentally, the
floppy disk has a write-protect notch. When the disk is
write-protected, you can read data, but you cannot write
the data or format the disk. It is recommendable to
write-protect floppy disks that contain important data
except when you write data to the floppy disk. To
write-protect a 3.5-inch floppy disk, slide the
write-protect notch located on its back.
The floppy disk is a very delicate storage medium. Dust or changes in temperature could
cause data to be lost. Data loss could also be caused by faulty operation and computer
trouble. To avoid such possible data loss, it is recommendable to back up important data
regularly. (Be sure to make back-up copies of the floppy disks that are included with NEC
Express5800/ft series.)
General Description 2-35