NEC Express5800 Series User Manual page 203

Installing and Using Utilities 5-19
Status of Logical PCI Slots
Because the I/O hub and display controller on a PCI module (IO module) are logical PCI slot
information, PCI module (IO module) are not influenced by them. Therefore, the "Status" of [PCI
slot (ID:0/10/102)] and [PCI slot (ID:0/10/103)] under [PCI module (ID:0/10)] and the "Status" of
[PCI slot (ID:1/11/102)] and [PCI slot(ID:1/11/103)] under [PCI module (ID:1/11)] in the FT tree on
a Data Viewer becomes "Online" and the status color becomes green.
Impact of Module Status Changes
PCI modules (IO modules), SCSI adapters, SCSI buses, and modules under the SCSI enclosure have
impact on each other. For example, when the "Status" item of a module changes to "fault," it may
be caused by another module's error. Therefore, you need to check the status of the other modules
based on alert information.
Status Color after Mounting a Hard Disk
When creating a new mirror, the status of the hard disk and its upper component, SCSI enclosure,
will continue to change after you mount a hard disk until the mirror is completed. The OS may take
several minutes to recognize changes of disk status or the disk may need to be rescanned. During
this process, the status color may turn to abnormal, but when the mirror is created successfully, it
will return normal.
LAN Monitoring Report
The LAN monitoring function defines the line status depending on the number of transmission
packets and the number of packet errors within a certain period. Thus, the LAN monitoring function
may report a line fault or high line load only in a temporary high line impedance state. If a normal
state recovery is reported immediately, temporal high line impedance may have occurred thus there
is not any problem.
LAN Monitoring Threshold
Because hardware faults on the network are found in the driver level, NEC ESMPRO Agent does
not monitor line faults.
Community Authority
Depending on your OS type or its version, settings for community, SNMP service's security
function, are not made, or default settings of authority are different
To enable the remote shutdown and threshold change functions via NEC ESMPRO Manager, make
settings of community and set its authority to "READ CREATE" or "READ WRITE."