NEC Express5800 Series User Manual page 291

Message
The driver started to set the
MTBF threshold.
The driver finished successfully
to set the MTBF threshold.
The driver started to set the
MTBF type.
The driver finished successfully
to set the MTBF type.
Board bootup error log detected
in the Module.
[FT LED: Amber Blink] It is
dumping it.
[FT LED: Amber On] MTBF of
the CPU module is below the
threshold.
[FT LED: Amber On] MTBF of
the IO module is below the
threshold.
[FT LED: Amber On] Module
broke down.
[FT LED: Amber On] Not able to
bind PCI Express 0. It has
broken down in the past.
[FT LED: Amber On] Not able to
bind PCI Express 1. It has
broken down in the past.
[FT LED: Amber On] Not able to
bind South Bridge. It has
broken down in the past.
[FT LED: Amber On] Not able to
bind Module. It has broken
down in the past.
[FT LED: Green On] The
system was duplex.
[FT LED: Off] The driver did not
bind the CPU module.
[FT LED: Off] The driver did not
bind the IO module.
[FT LED: Off] The Network
device is not duplex.
[FT LED: Off] The SCSI device
is not duplex.
Meaning
The driver started setting the
MTBF threshold.
The driver successfully set the
MTBF threshold.
The driver started setting the
MTBF type.
The driver successfully set the
MTBF type.
An error log at the module
startup was detected.
[FT LED: Amber Blink] Collecting
dump.
[FT LED: Amber On] The MTBF
of the CPU module is lower than
the threshold.
[FT LED: Amber On] The MTBF
of the IO module is lower than
the threshold.
[FT LED: Amber On] The module
failed.
[FT LED: Amber On] The PCI
Express 0 cannot be bound
because it has failed in the past.
[FT LED: Amber On] The PCI
express 1 cannot be bound
because it has failed in the past.
[FT LED: Amber On] The South
Bridge cannot be bound because
it has failed in the past.
[FT LED: Amber On] The module
cannot be bound because it has
failed in the past.
[FT LED: Green On] The system
was duplexed.
[FT LED: Off] The CPU module is
not bound.
[FT LED: Off] The IO module is
not bound.
[FT LED: Off] The network device
is not duplexed.
[FT LED: Off] The SCSI device is
not duplexed.
Troubleshooting 7-19
Action
The server is operating
normally.
There may be problem in
the system environment.
Contact your sales agent.
The server is operating
normally.
If the message is recorded
frequently, there may be
problem in the system
environment. Contact your
sales agent.
There may be problem in
the system environment.
Contact your sales agent.
The server is operating
normally.
Take necessary actions
referring to
"Troubleshooting" in the
User's Guide.