NEC Express5800 Series User Manual page 117

See the table below for setup options on the screen.
Option Parameter
User Password [Clear]
is
Set
Supervisor [Clear]
Password is
Set
Set User [Enter]
Password
Set Supervisor [Enter]
Password
Password on [Disabled]
boot
Enabled
Switch Inhibit [Disabled]
Enabled
IMPORTANT:
If you have logged in SETUP by using the Supervisor Password, you can check and change all
settings. If you have logged in SETUP by using UserPassword, you see the settings but cannot
make changes on the settings except System Time, System Date and User Password of Main.
Description
Indicates User password setup status (view only).
Indicates User password setup status (view only).
Press Enter to display the user password entry
screen. With a user password, accessing the
SETUP menus is restricted. This option is
available only if the Supervisor Password is
specified.
Press Enter to display the supervisor password
entry screen. This option is available only when
you log into the SETUP utility with the supervisor
password.
Specify whether to request a password entry at
boot-up. User password setup is required
beforehand.
Enable or disable the POWER switch on the
server. If you select to enable, the switch will be
disabled.
System Configuration 4-19
[ ]: Factory-set