NEC Express5800 Series User Manual page 226

5-42 Installing and Using Utilities
System Configuration
System Configuration contains the following information:
Quick dump that is harvested at the same time of system reboot.
Select the [Enable] radio button to obtain quick dump at a system crash.
When a quick dump cannot be produced, a dump is produced by the standard dump function.
Automatic firmware update.
Select the [Enable] radio button to enable automatic firmware update. When this item is enabled and
when one module is started, the firmware (System BIOS) of the other module started later will be
automatically updated to the one that is already running if it is old.
Automatic module start.
Select the [Enable] radio button to enable the automatic module start. When this item is enabled and
when the server is running in the simplex mode with one module, if the other module is inserted to
the chassis, it will be automatically started and modules will become duplex.
The module POWER switch of the server is always enabled regardless of this setting. (The module
stopped by the module POWER switch can be started even when this setting is disabled.)
The following buttons are displayed for System Configuration:
Item
Apply
Default
These operations cannot be performed while collecting dump or updating firmware. Wait until such
processing is finished to perform the operations in the table.
Module#n
Module contains the following information:
Item
Device
Status
CPU Module(ID:n/m)
CPU Module contains the following information:
Item
Status
Applies the system configuration to the server
Resets the system configuration of the server to the default.
CPU module name and PCI module name
Status of the CPU module and the PCI module
Status of the CPU module
Description
Description
Description