Inserting The Memory Card; Ejecting The Memory Card; Fitting The Unit Bracket - Becker READY 50 Operating Manual

>>> GENERAL OPERATION

Inserting the memory card

> Remove the memory card from its
> D
packaging without touching or soiling
> GB
the contact bar.
> Hold the memory card so that the
> F
contact strip is facing towards the rear
> I
of the unit.
> Guide the memory card into the card
> PL
slot.
> Exert a little pressure and slide the
memory card into the card slot until it
snaps in.

Ejecting the memory card

The card slot ejects the card so that you
can pull it out with two fingers.
> Use your finger to gently press the
memory card against the spring force
into the card slot and then release it.
The card is ejected.
> Remove the memory card and place it
in the packaging while ensuring not to
touch contact bar.
22
Unit bracket
The Navigation device can be attached
directly to the windscreen with the unit
holder.
Note:
The Navigation device and unit bracket
must not be exposed to long periods of
direct sunlight. Temperatures inside the
vehicle of +70 °C and higher may
damage parts of the bracket.

Fitting the unit bracket

Note:
Fasten the unit holder such that your
field of vision is not impaired when the
Navigation device is installed and
ensure that the unit is outside the
deployment area of the airbag.
Ensure that the electrical connection
cable does not hamper you from
accessing the vehicle's controls.
Clean the attachment surface on the
windscreen to ensure that it is clean and
free of grease. Do not use greasy or
soapy cleaning agents.