Enhancements
Release M.10.66 Enhancements
ProCurve(config)# logging priority-descr severe-pri
Figure 30. Example of the Logging Command with a Priority Description
Note
A notification is sent to the SNMP agent if there are any changes to the syslog parameters either
through the CLI or with SNMP.
Command Differences for the ProCurve Series 2600/2800/3400cl/6400cl
Switches
CLI Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not have the following
CLI logging commands:
•
logging severity
•
logging system-module
SNMP Commands. The ProCurve series 2600/2800/3400cl/6400cl switches do not support the
following SNMP objects:
•
hpicfSyslogPrioritySeverity
•
hpicfSyslogSystemModule
Operating Notes
Duplicate IP addresses are not stored in the list of syslog servers.
■
If the default severity value is in effect, all messages that have severities greater than the
■
default value are passed to syslog. For example, if the default severity is "debug", all messages
that have severities greater than debug are passed to syslog.
There is a limit of six syslog servers. All syslog servers are sent the same messages using the
■
same filter parameters.
■
An error is generated for an attempt to add more than six syslog servers.
142