HP ProCurve Series 3400cl Release Notes page 156

Software Fixes in Release M.08.51 - M.10.72
Release M.08.61
2. In show CDP the Yes is changed to Yes,(Receive Only).
CLI (PR_1000192677) — Show access-list ports <tab> does not list the all keyword. The
■
command only shows [PORT-LIST] as input for the command.
Console/TELNET (PR_1000195647) — When a console or TELNET session hangs,
■
issuing the 'kill' command also hangs.
■ Crash (PR_1000193582) — Software Exception when clicking on the Identity Tab of a
Member Switch in the Web user interface. The switch may crash with a message similar to:
Software exception at http_state.c:1138 in 'mHttpCtrl'
0x1722cf8.
■ Crash (PR_1000196129) — Removing the J8434A module (10Gigabit) creates configura-
tion problems and sometimes causes the switch to crash.
Crash (PR_1000199535) — Sometimes the command show boot-history results in a bus
■
error. (pre-release)
■ Crash (PR_1000201614) — When the switch is set with a 16-character manager password
in the setup menu, a 'Bus error' crash may occur. The bus errors vary.
■ Crash (PR_1000204782) — Bus error when copying a configuration to the switch. The
switch may crash with a message similar to:
Bus error: HW Addr=0x594f5531 IP=0x004ff8a8 Task='mftTask' Task
ID=0x126eba0 fp: 0x00000000 sp:0x0126e7d0 lr:0x001e655c.
IP Addmgr (PR_1000200338) — CPU-based protocol stops working. The memory corrup-
■
tion of text caused many tasks to hang or be SUSPENDED, since the switch is trying to
execute invalid instructions.
MIB (PR_1000206519) — The RFC 3636 MIB implemented is not correct. (pre-release)
■
■ Open VLAN (PR_1000210932) — Open VLAN mode (Unauth VLAN) does not work with
any Port-Security Learn-Mode.
Port toggle (PR_1000216940) — 10 Gigabit, CX4 port toggles (that is, Link up, Link down,
■
and so on). (pre-release)
■ QOS (PR_1000200746) — Configure a dscp-map name that requires quotes such as "Code
Point 0". Save this name in the configuration file and reboot the switch, the name is truncated
to "Code".
QOS (PR_1000213489) — The command show QOS resources displays blank information
■
for the 10 Gigabit module.
SNMP (PR_1000196170) — Traps are not buffered before the IP stack is initialized, causing
■
the possibility of missing some traps generated during startup.
■ Syslog (PR_1000215699) — Pre-boot event log messages are cached for syslog and syslog
is only able to send those cached entries after the switch fully boots. The cache size is limited,
so in some cases, not all event log messages will be sent via syslog.
146
TaskID =