Release M.10.39 Enhancements - HP ProCurve Series 3400cl Release Notes

Enhancements

Release M.10.39 Enhancements

[version <1 | 2c | 3>]
[<none | all | non-info | critical | debug>]
You can see if informs are enabled or disabled with the show snmp-server command as shown in Figure
11.
ProCurve(config)# show snmp-server
SNMP Communities
Community Name
---------------- -------- ------------
public
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Send Authentication Traps [No] : No
Informs [Yes] : Yes
Address
---------------------- ---------------- -----------------
--
Excluded MIBs
Snmp Response Pdu Source-IP Information
Selection Policy
Trap Pdu Source-IP Information
Selection Policy
Figure 11. Example Showing SNMP Informs Option Enabled
Release M.10.39 Enhancements
Release M.10.39 includes the following enhancement:
120
Select whether SNMP traps or informs are sent to this management station.
For more information on SNMP informs, see
SNMP Informs" on page
Select the version of SNMP being used.
Note: SNMP informs are supported on version 2c or 3 only.
Options for sending switch Event Log messages to a trap receiver. The levels
specified with these options apply only to Event Log messages, and not to
threshold traps.
MIB View Write Access
Manager Unrestricted
| Community
: Default rfc1517
: Default rfc1517
"Enabling and Configuring
119.
Events Sent in Trap