HP ProCurve Series 3400cl Release Notes page 144

Enhancements
Release M.10.43 Enhancements
ProCurve(config)# show ip source-lockdown bindings
Dynamic IP Lockdown (DIPLD) Bindings
Mac Address IP Address
----------- ----------
001122-334455 10.10.10.1
005544-332211 10.10.10.2
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 21. Example of show ip source-lockdown bindings Command Output
In the show ip source-lockdown bindings command output, the "Not in HW" column specifies whether
or not (YES or NO) a statically configured IP-to-MAC and VLAN binding on a specified port has been
combined in the lease database maintained by the DHCP Snooping feature.
Debugging Dynamic IP Lockdown
To enable the debugging of packets dropped by dynamic IP lockdown, enter the debug dynamic-ip-
lockdown command.
Syntax: debug dynamic-ip-lockdown
To send command output to the active CLI session, enter the debug destination session command.
Counters for denied packets are displayed in the debug dynamic-ip-lockdown command output. Packet
counts are updated every five minutes. An example of the command output is shown in
When dynamic IP lockdown drops IP packets in VLAN traffic that do not contain a known source IP-
to-MAC address binding for the port on which the packets are received, a message is entered in the
event log.
134
VLAN Port Not in HW
----- ----- ---------
1111 X11
2222 Trk11 YES
Figure 22.