HP ProCurve Series 3400cl Release Notes page 151

Adding a Description for a Syslog Server
You can associate a user-friendly description with each of the IP addresses (IPv4 only) configured
for syslog using the CLI or SNMP. The CLI command is:
Syntax: logging <ip-addr> control-descr <text_string>]
no logging <ip-addr> [control-descr]
An optional user-friendly description that can be associated with a server IP address. If
no description is entered, this is blank. If <text_string> contains white space, use quotes
around the string. IPv4 addresses only. Use the no form of the command to remove the
description.
Limit: 255 characters
Note: To remove the description using SNMP, set the description to an empty string.
ProCurve(config)# logging 10.10.10.2 control-descr syslog_one
Figure 29. Example of the Logging Command with a Control Description
C a u t i o n
Entering the no logging command removes ALL the syslog server addresses without a verification
prompt.
Adding a Priority Description
You can add a user-friendly description for the set of syslog filter parameters using the priority-descr
option. The description can be added with the CLI or SNMP. The CLI command is:
Syntax: logging priority-descr <text_string>
no logging priority-descr
Provides a user-friendly description for the combined filter values of severity and
system module. If no description is entered, this is blank. If <text_string> contains
white space, use quotes around the string. Use the no form of the command to remove
the description.
Limit: 255 characters
Enhancements
Release M.10.66 Enhancements
141